Dangerous Goods safety

Estimated reading time: 1 min

Lessons learned from the ammonium nitrate emulsion tanker explosion

In October 2022, a tanker trailer carrying ammonium nitrate emulsion (ANE) caught fire and exploded approximately 150 kilometres east of Laverton in WA. ANE is commonly used in the manufacture of explosives.

long dirt road

The incident began with a tyre fire on the rear tanker trailer. When attempts to put out the fire using fire extinguishers were unsuccessful, the driver detached the rear tanker and dolly, drove to a safe distance and set up a 3-kilometre exclusion zone. The intense and prolonged fire caused the ANE to spill and eventually explode two hours later. The blast left a large crater in the road and destroyed the tanker and dolly.

This explosion was the world’s first known detonation involving ANE during transportation since the introduction of bulk transport in the 1980s.

The incident investigation prompted a comprehensive review of the hazards associated with the transport of ANE. The Department of Energy, Mines, Industry Regulation and Safety (DEMIRS) took immediate steps to educate both industry and the public through the release of an animated reconstruction of the incident and an incident alert. Publication of the investigation report followed the review, along with a condensed version with key information for drivers and transport companies.

Work continues as DEMIRS drafts legislative amendments and develops a new code of practice with the aim of improving the transportation of dangerous goods by even higher safety standards, thereby reducing the risk of such incidents.

Lessons for industry

DEMIRS’ investigation resulted in 16 recommendations, including:

For drivers:

  • pull over to an area where the product will flow away from the vehicle
  • attempt to extinguish the fire in its early stages using pressurised foam or water- based systems
  • establish an exclusion zone, alert emergency services and evacuate if the fire is uncontrollable.

For transport companies:

  • fit hubs and tyres with temperature and pressure monitoring systems
  • increase maintenance schedules, especially for vehicles traveling on poor roads
  • provide drivers with comprehensive fire fighting and emergency response training
  • improve vehicle design to include heat- shielding mudguards, fire screens and protect critical components.

If you are interested in the safety measures being introduced by WorkSafe, the draft code of practice, Minimising the risk of tyre fires when transporting ammonium nitrate explosion risk goods, will be available for public consultation shortly. Keep an eye on the open consultations page for its release.

Other good reads

Read other articles here.